A slow refrigerant leak quietly kills cooling and can burn out the compressor. Easy HVAC connects you with pros who find and seal the leak — then recharge to spec, not just top it off.
Comparing options? Take a look at the full service lineup first.
Refrigerant doesn’t get “used up” — a sealed AC never needs more unless it’s leaking. So when your system is low, there’s a leak somewhere: a corroded coil, a loose flare fitting, a worn Schrader valve, or a pinhole in the copper. In Tampa’s salt air and humidity, coil corrosion is especially common.
As the charge drops, cooling fades — the air gets warmer, the system runs longer, and the coil can ice over. Worse, a compressor starved of refrigerant runs hot and can burn out, turning a modest leak repair into a compressor or full replacement. That’s why a simple “top-off” without finding the leak is a waste — it buys weeks, then you’re back where you started.
A licensed pro doesn’t just add refrigerant. They pressure-test and use an electronic leak detector (and sometimes UV dye) to pinpoint the source, then repair it — tightening or replacing a fitting, replacing a Schrader valve, or repairing/replacing a leaking coil. On badly corroded coils, replacing the coil is often the durable fix.
After the repair, the system is evacuated with a vacuum pump to remove moisture and air, then recharged with R-410A by weight to the manufacturer’s specification — the only way to get accurate, efficient cooling. If your system still uses R-22 (Freon), the pro will explain why an aging R-22 unit with a leak is usually better replaced than recharged.
The pro puts gauges on the system and measures pressures and superheat/subcool to confirm an undercharge.
Electronic detection and, if needed, UV dye pinpoint the exact source — coil, fitting, valve, or line.
The pro seals or replaces the leaking component so the fix actually holds.
The system is vacuumed to remove moisture, then recharged with R-410A by weight to spec.
Cooling, pressures, and the temperature split are re-measured to confirm a proper charge.
Get the leak found and sealed — not just topped off — by a licensed, EPA-certified local pro.
Call (813) 739-2743Refrigerant is federally regulated and requires EPA certification to handle. Every pro we refer is certified — no risky DIY cans, no shortcuts.
We connect you with pros who locate and repair the leak, then recharge by weight — so you’re not paying to refill a system that keeps leaking.
There’s no safe DIY for refrigerant — it requires EPA certification to handle, and “stop-leak” cans sold online can damage the system and void warranties. What helps: if the coil or line is iced over, switch the system to fan-only to thaw it so the pro can test accurately. Note whether you’ve had refrigerant added before and when — a system that needs repeated top-offs has a leak that should be found and sealed, not fed. Then call and let a certified pro handle it.
Electronic leak detection, proper R-410A recharge, and honest advice across Tampa and Hillsborough County.
Call (813) 739-2743Easy HVAC connects you with pros for refrigerant / freon leak repair in Tampa and every community below.
Serving Tampa, FL and all of Hillsborough County. Easy HVAC connects you with licensed, insured local HVAC pros, available 24/7.
Talk to a real person 24/7 and get connected with a licensed local pro — fast, with an honest price before any work.
Call (813) 739-2743Easy HVAC is a free referral service, not a real HVAC contractor. All work is performed by independent, licensed and insured local pros. Not affiliated with any other company.
