Most Tampa homes run a heat pump for both cooling and heat — so one fault can cost you both. Easy HVAC connects you with licensed pros who fix reversing valves, defrost boards, and strip heat fast.
Not the service you need? See the full range of Easy HVAC services.
A heat pump is really an air conditioner that can run in reverse: in summer it pulls heat out of your home, and on cool Tampa nights it pulls heat from the outdoor air and moves it inside. That versatility is why it’s the dominant system here — but it also means the same unit works nearly year-round, and a single failure can knock out both modes.
The failures the pros in our network see most are a stuck or leaking reversing valve (the part that flips between cooling and heating), a failed defrost board or sensor, and a bad strip-heat contactor that leaves the backup electric heat unable to kick in on a cold morning. On the cooling side it’s the familiar list — a weak capacitor, a dirty outdoor coil, or low refrigerant.
A licensed pro tests the whole system rather than guessing at one mode. They confirm the reversing valve is switching properly, check the defrost board and sensor, test the strip-heat contactor and elements, and put gauges on the refrigerant circuit. Because a heat pump shares parts with your AC, one visit can address both a summer no-cool and a winter no-heat concern.
Most repairs finish in a single visit with an upfront price. If the reversing valve or compressor has failed on an aging unit, the pro will give you an honest comparison against a new heat pump — sometimes replacement is the smarter money on a system near the end of its life.
No heat, no cooling, or cold air in heat mode — tell us what the system is doing and we dispatch a pro.
The pro checks the reversing valve, defrost board, strip heat, and refrigerant — the whole system, not one mode.
You see the cause and the price before any work begins.
Reversing valve, defrost board, contactor, capacitor, or refrigerant — fixed to restore both heating and cooling.
The pro runs both modes to confirm the unit cools, heats, and defrosts correctly.
Cooling or heating, one call connects you with a licensed pro who knows Tampa heat pumps inside and out.
Call (813) 739-2743Most Tampa homes run heat pumps, and the pros we refer service them constantly — reversing valves and defrost boards aren’t a mystery to them.
Because a heat pump cools and heats, a single visit can resolve a summer no-cool and a winter no-heat concern at once.
Know that a heat pump briefly blowing cooler air in heat mode can be normal — during a defrost cycle the unit reverses for 30 seconds to 10 minutes to melt frost off the outdoor coil, and the indoor temperature may dip a degree or two. If it’s blowing cold for much longer, check that the thermostat is on “heat” (not “cool” or “emergency heat” unless needed) and that the air filter is clean. Note whether the problem is heating, cooling, or the switch between them — that detail helps the pro zero in. Then call.
Heat pump repair by licensed local pros across Tampa — reversing valves, defrost, strip heat, and refrigerant.
Call (813) 739-2743Easy HVAC connects you with pros for heat pump repair in Tampa and every community below.
Serving Tampa, FL and all of Hillsborough County. Easy HVAC connects you with licensed, insured local HVAC pros, available 24/7.
Talk to a real person 24/7 and get connected with a licensed local pro — fast, with an honest price before any work.
Call (813) 739-2743Easy HVAC is a free referral service, not a real HVAC contractor. All work is performed by independent, licensed and insured local pros. Not affiliated with any other company.
